This is for anyone running Prusaslicer.

I decided to upgrade from my Creality Ender 3 pro and found this printer which seemed to do everything I needed for a good price.

After some trial and error and inspecting the gcode of some builtin test models in the printer firmware. I came up with this config for the printer and PLA/ABS/TPU filaments. Though I'm always tweaking it.

Last updated: 6th Jan 2026

It's not perfect, but depending on the print, it does a pretty good job.
This was printed using the hardened steel 0.6mm nozzle. The seams are annoying and adding scarf seams doesn't seem to have any affect.

There is an inbuilt camera, but unfortunately I haven't been able to stream the feed yet. Apparently if you install VLC and open the network stream to http://<IP ADDR>:18088/flv it should work. But I get nothing, not even an error.
Watch this space as I will fix this!