This is for anyone not running Windows, MAC or Ubuntu.

I decided to upgrade from my Creality Ender 3 pro and found this printer which seemed to do everything I needed for a good price.

After some trial and error and inspecting the gcode of some builtin test models in the printer firmware. I came up with this config for the printer and PLA/ABS filaments.

I used this to print speaker mounts for an upgrade project on the car.
MG4 Speaker Upgrade

There is an inbuilt camera, but unfortunately I haven't been able to stream the feed yet. Apparently if you install VLC and open the network stream to http://<IP ADDR>:18088/flv it should work. But I get nothing, not even an error.
Watch this space as I will fix this!